Thanks to onuno
How to make an AU (AutoUpdate) Card
1 Working MK (00,01,04), SA or/and UA
2 AU hex-file
3 Editor for that file
4 A Card and programmer for it.
Follow that path:
1. Open AU-hex (eeprom-hex) with editor
2. Choose Provider
-if there aren’t, add provider ID, add provider name
3. Add keys 00, 01 and 04 to their places
-if you have key 08, put it to it’s place
4. Add SA to it’s place
-if there is a place for CUSTPW, put CUSTPW to it, or leave it as 00
5. Add UA to it’s place
(if you haven’t UA, you can try following;
-Write first two bytes 00, write SA, write CUSTPW(you can’t leave this as 00))
6. Save your hex-file
7. Select next provider, and repeat 3 –7 unless you have edited all needed providers
8 After you edited all providers, program your card
Now you have AU-card ready for use, put it into CAM.
AU: Tune the channel (provider) you want update. Reset! (turn receiver off/on with the channel you want updated, or pull out the card and put it in again)
If you had working mk/SA/UA your card will be updated after few minutes…..
Repeat process with every provider you edited…..
Have fun and enjoy the show……
Kui soovid välja käia mingi tarkusetera siis postita siia. Vastusteks olgu ainult teema edasiarendused.
1 postitus • 1. leht 1-st
Kes on foorumil
Kasutajad foorumit lugemas: Registreeritud kasutajaid pole ja 1 külaline